Jump to content

streetw0lf

Members
  • Posts

    27
  • Joined

  • Days Won

    1

streetw0lf last won the day on December 27 2017

streetw0lf had the most liked content!

Reputation

11 Good
  1. I'm having a similar issue. If I change something in the BIOS on my Motherboard like a frequency or timing then save and exit my monitor 95% of the time fails to detect either a DP or HDMI signal. All i see is the monitor LED fluctuate between orange and white thus leaving me with a brick. By hooking up another monitor which works perfectly I can get the XENEON to work properly until the next time I change the BIOS. Do you see on the monitor when booting a no signal message?
  2. You got to be kidding? :mad: Do you have a link where Corsair says it's not supported not that I don't believe you. Back to v3 then.
  3. Sorry if this was addressed already. My H115i is not detected by v4. Windows 10 recognizes it. I did a few uninstalls and installs to no avail. Any ideas on my problem or a link to a post that has more info? Thanks.
  4. I read that the LGA 1200 socket on the upcoming Z490 mobo which replaces the LGA 1151 on the Z390 mobo has the same footprint therefore all cooling solutions will work without a new bracket. I just want to confirm that I can use my H115i bracket on a Z490 mobo when I get one. Thanks.
  5. See my specs. Corsair Vengeance LPX 32GB 4x8GB CMK32GX4M4E4133C19 @ 4000Mhz. 16-17-17-36-2CR. My memory is on my motherboards memory support list to run at 4133Mhz. The most I can achieve with upping my CPU frequency slightly is ~4022Mhz. I tried relaxing all timings and can't get any higher. Even at stock speeds I can't go any higher. Is this just a situation where the gods have deemed that my mobo and memory just won't go any higher or is there some other setting in the UEFI that might do the trick? I've tried just about every setting I could think of. Now 4000Mhz with my tight timings is nothing to complain about but... you know how it goes. I am able to run Memtest86+ at 4133 till the cows come home with no errors. I can boot into Windows and run fine. At some point however, I will Blue Screen.
×
×
  • Create New...