abzjji

Is there software I can use besides icue to setup the HS60 Headphones? Dont really get why I have to install this 1GB bloatware if I just have headphones. I primarily want to have an equalizer to improve sound of the headphones a little bit. I dont mind losing the "7.1 Virtual Sound" feature as it doesnt improve audio cues by enemy players at all in the games I tried.

Which X370 Board should I get for my Ryzen Build (1700X)? I already own this RAM from my old PC: 2x 8GB Corsair Vengeance LPX CMK16GX4M2B3000C15 So which Board would be a good choice to not run into compatibility issues? I wanted to buy the Asus PRIME X370-PRO or STRIX X370-F but they both seem to not have this ram in their QVL =(

dram: 1.35v sa+io: 1.175v

3100Mhz and the default Timings (CL15-17-17-35)

Did some testing and as soon as I set 3200mhz ram my system is not booting anymore. Get just a blackscreen after leaving bios and have to make a reset. 3100mhz still working just fine. I'm on 3202. Any way to get 3200mhz to work ?

http://i.imgur.com/ZvgMDqq.jpg http://i.imgur.com/CsHZ8qE.jpg Timings and voltages I use with mine and everything is working without issues. Left everything at default except clock and main timings. DRAM voltage is bugged though. It shows twice the voltage it actually is for some reason.

3202 is working perfect with my CMK16GX4M2B3000C15. I didnt try XMP though. I set clock, timings and voltages manualy because xmp always set crazy high VCCIO and SA voltages.

I would switch for the asrock z170 extreme4 if i still had the chance.

@Finalizer72 Try to set everything manually and dont use xmp.

I'm also using Corsair Vengence 3000Mhz Ram on my z170 pro gaming. I never had problems with the pc not booting up. But if I enable XMP it sets my Vccsa and Vccio voltage to some crazy high values (both of them around 1.3V). Most ppls run their 3000mhz ram on 1.10V or less on SA/IO. Why is the voltage so high? A lot of OC guides recommend not to go higher than 1.25V. If I dont use XMP but manual ram settings, what values I have to set?