Ros

Hi, Every time I start Ryzen Master after iCue is already running, my RGB leds from my Dominator memory modules freeze. The only way that they wake up again is restart whole system. All other RGB lighting are fine (fans, led strips, AIO). If Restart my system and start Ryzen Master as soon as I can and before iCue the RGB light work without any issue. Any Idea if there's any fix? Thanks My specs: Ryzen 9 3900X 4 sticks 8GB Corsair Dominator (Black, 3200Mhz) Aourus Elite X570 with the latest bios firmware. All iCue components are also updated. iCue version 3.38.61 doesn't matter at all because the issue persist in every update of the software. Ryzen Master 2.6.2.1818

Bump message any help from Corsair official support team on this forum?

I have a similar issue.. I have a Light Node Pro Channel 1 with 4 ML140Pro fans they are working fine. The channel two since 2 days ago is acting weird... in this channel I have 3 LL120RGB fans attached, fan 1 is ok, fan 2 part of the bottom section of outer lights are stuck in one color, and the fan 3 is complete stuck in the same color as fan 2. Sometimes this fans change the color when I try some restarts, hardware lighting color change... even sometimes they run some animation with lots of glitches in the RGB. I found if you have a solid color and lower the brightness to almost 0 this fans make some animations, not smooth and with glitches. So maybe is a power issue in channel 2?

Hi folks, Since yesterday all my setup was working just fine... but something happens, one LL120 fans connected to 2nd channel lighting node pro the RGB of the fan went off.. I checked the RGB profile and applied a new one to check; I can see on that this LL120 some animations wont work, or work intermittent. Also switching between profiles I need to reapply all RGB profiles on the 3 LL120 on that channel. Since this problem I updated the iCue to 3.36.125v, restarted the iCue service various times, shut down the PC and restarted some others, forced firmware update on LNP. Also the hardware illumination on the LNP when the computer is restarted or powered down also is acting weird on that channel. Any idea... is LNP channel 2 faulty without reason? My setup... On LNP Channel 1 -> 4 ML140 RGB On LNP Channel 2 -> 3 LL140 RGB Commander Pro to control all fans and also 4 RGB strips 4 Sticks of RGB Dominator RAM 3 More ML120 no RGB on my AIO H150i PRO Commander Pro voltage report are: 12v rail 11.89-11.93v 5v rail 4.64-4.83v 3.3v rail 3.38v My Power Supply is a CoolerMaster 650W GTX1080 AMD 3900X

Any way to mod this profiles? and where they are? Thanks

Hi I tried this method with no luck for my H150i Pro, al my fans and keyboards works as expected but not the RGB pump. Any idea?