Jump to content

MROOD

Banned by Moderators
  • Posts

    35
  • Joined

Reputation

10 Good
  1. Can someone do the iron man profile for cue 2? Iron man profile is one of the best looking profiles with its striking red and orange glow with the white flashing centre. Unfortunately I lost all my profiles whilst jumping on the Cue2 software. Ive created a few of my own for the K95 and MM800 Polaris mouse pad but they are not as good as the pros Ive tried to do the iron man profile but really cocked up so anyone: IRON MAN PROFILE for the K95 and MM800 Mouse pad please!
  2. ahh man I spent 3 hours cutting away with a craft knife i cit out the squares perfectly The square cut out fit perfect over the keys but the 2nd half of the keyboard does not align with the squares, theres about alteast an inch in discrepancy, so I had to cut the cut out in 4 places and now it fits but i have gaps I downloaded and printed the same size but i dont know what happened I wish we could just buy this stuff!
  3. i downloaded the k95 pdf, spent 3 hours carving out the square holes, i did it perfectly, everything fits but the middle was off by 1cm which is alot, both left right sides fit perfect but the middle was a disaster, so I just cut the middle bit out, my keyboard rgb now looks better and it looks the same as my strafe apart from the middle.
  4. ahh ok then i will accept your advice and not use cardboard, i will use 2 sheets of standard white paper make the cut and carefully apply the paper flat on the keyboard without glue, just thinking do I need a tool to remove the key caps from the keyboard?
  5. hello basically I have measured the boxes from the link and i have printed it out as it is without changing the size, the boxes top to bottom is exactly 1.5cm same left to right 1.5cm this is the size of the square box on the keys caps, Now the RED letter L is exactly 10mm, so if the scaling is 10mm and is correct for me that means im ready to cut out the boxes right? I'll join the to papers and will glue it on a white cardboard then will cut out the boxes and hope for the best. though when i place the white cardboard on the keyboard do I just place it on? nothing to put on the base so it sticks to the surface? or will the key caps be suffice?
  6. sorry to post again can you help me as when i print it shows on my pc as 245% which is way to big, what is the exact in percentage in terms of size when printing out of my printer, is it 100%? I will use white paper or white card board, then i will use a slicing knife to cut the holes, i do not have access to advanced tools edit: # just to add i have the pdf files i downloaded from the previous page, its a print of the keyboard in whole, looking at the pic it seem if i print it wont fit hence why a exact numbeer in % will give me a perfect fit, unless i print it and cut it out around 30 times in different sizes, that will take agaes Also how on earth do you take the caps off a k95, i tried a bit and didnt want to pull to hard in case i break somthing, do i just pull it out hard?
  7. mate can you advise me on how you did the print?? ok when i print the pdf it keeps on showing as 245% in size??!! what percentage do i re-size the print out so it fits? is it 100% and also can anyone tell me how to take the key caps off the keyboard? i do not have any special tools the keyboard looks amazing and i would like to have this mod on my new k95
×
×
  • Create New...