stebrick

Sorry another question, is it receommended to set this pump at full speed 24/7 (or 12-15/7) if I dont mind about the noise? By doing so would it further reduce the lifespan of this cooler?

Shoot! Got it now, tyvm. I can set the pump speed at 2850 now by following your instruction. I suppose this is the max speed this pump can offer? I must say this's kinda unintrutive setting. What I did was to click all the devices on the left panel, then click the "extreme" and edit all devices on the right. However this didn't change any setting on the pump speed at all. I'm however more confused why the pump speed is not programmed to change with the temperature of the CPU by default. Doesn't it make more sense that way? Now I got another question, the temperature as shown in iCue is very different from the MSI Afterburner (Proof here: https://i.imgur.com/vjtAVCz.jpg). May I know why? Which one is supposed to reflect the true temperature of CPU? From my feeling it seems afterburner is more accurate since my room is vastly hotter upon reaching 7x degree. The figure in iCue just doesn't make any sense or have any probative value. Do I have to recalibrate the sensor or something else? Actually I'm not even sure where did they put the temp sensor :rolleyes:

Also, i cant do anything over the pump speed in bios or dragon centre. I'm using MSI Godlike z390 motherboard and haven't messed with any of its setting. Everything is default setting so far. Just FYI.

The PC I'm using is my fresh build which was installed by the computer shop few days ago. I notice from iCue and bios that the AIO H150i pump speed is always spinning between 9xx and 10xx RPM, which is unusually low according to what i've found from google. I cant even change the pump speed profile in iCue (only the fans speed of the radiaor can be changed). In my situation, when the CPU (i9-9900k) usage is near 30% during gaming, the temperature is around 7x degree and the pump speed remains the same. It's 50 degree during non-gaming. What's the plausible cause(s) of my pump speed issue? I am not familiar with hardware stuff so I cant diagnose the issue myself. Some help from you guys are much appreciated. Thanks.