- 260,685 Members
- 1,225,450 Posts
- 383 Online Now
Featured Posts
See all featured-
- 0
- 8
System Build InspirationStart Building with CORSAIR BUILD KITS
-
- 0
- 23
New Product ReleasesA Great Day for DIY – Introducing a Multitude of New Components
-
- 2
- 17
New Product ReleasesIntroducing the CORSAIR RMx SHIFT Series™ 80 PLUS Gold Fully Modular ATX Power Supplies
-
- 1
- 7
New Product ReleasesIntroducing the CORSAIR TC100 RELAXED Gaming Chair
-
- 0
- 1
New Product ReleasesLaunching the CORSAIR XENEON FLEX 45WQHD240 45-Inch OLED (3440x1440), 240Hz, Bendable UltraWide Gaming Display
Trending
Go to the forums-
RM750e + RTX 4070 Super
muvo replied:
almost forgot, you need the type 4 cable for your graphics card: 600W PCIe 5.0 12VHPWR Type-4 PSU Power Cable
By Menmei
Started5 -
Optimal way to connect 12 fans + xd5. I have 2 commander XT.
c-attack replied:
Are you asking about speed control or RGB control? For speed control, the easiest solution is to take any 2 of your LL or SP-Elite fans and pair them with a standard PWM splitter. That will free up a slot for the XD5 PWM. No need for individual fan speed control all the way through an one paired set of fans should not bother the controller. RGB is more complicated. You have two RGB channels available, one on each Commander XT. The XD5 can connect directly to any one of these. However, you also may need one for the strips. If the XT will let you piggy back those on the XD5, great. That leaves you one open channel for the CPU block. I don't know of any European based suppliers, but there are 3rd party adapters to connect a 'motherboard style' 5v ARGB connector to a Corsair style one. My preference would be to use that to connect to the XD5 and you can tell CUE it is a XC7 block and it will create an appropriate number of LEDs. This is what I do with my Velocity 2 block. This is an example of one that would work.
By doverkan69
Started4 -
Corsair 2500X build in white
rjohnson11 replied:
I put the lower fans upside down and fixed this for the final picture.
By rjohnson11
Started3 -
Darkstar wear and tear quick?
c-attack replied:
Hydrochloric Acid (HCl). Not a serious comment. I think the wear is both unusual and extreme. I have not seen anything even close to that over the product lifespan. Contact Support as means to replacement. However, the soft tactile construction on that mouse may lend itself to more wear and tear compared to other mice.
By GASHED
Started3 -
M55 How to permanently disable left site buttons?
feb43 replied:
Hello, thanks, that’s I want to do. Otherwise, I’m obliged to launch iCUE at every PC start which is not confortable. I will try your suggestion which seems to correspond to my needs. Thanks for your help. Best regards, François
By feb43
Started2 -
Save all software to hardware assignements
cbns replied:
> the individual device must be able to execute the action yes, obviously. > The libraries do allow you to copy/paste in the respective modes no they don't. Copy just creates a copy. You cannot paste it then into the hardware profile. That would be too easy. You haven't offered anything to contradict what I have said. Where appropriate, it shouldn't be necessary to rewrite all the actions and lights from scratch for both hardware and software.
By cbns
Started2
