Hi there everyone,
The corsair dominator memory I currently use is not running at 533/1066 MHz. (specs in profile). To what should I change my settings in order for the memory to run at 1066 MHz?
My FSB has a frequency of 1066 MHz, so it should be supported. (I installed all modules in a set according to their kit, so the set in Slot #1 and Slot #3 = Revision 2.10 | Slot #2 and Slot # 4 = Revision 1.1)
If 533/1066 MHz isn't possible/favorable, then what would the best settings be for these specs?
PS: I'm upgrading my mobo to a [P5Q DELUXE] + [Intel Core 2 Quad Q9550] in about 7 months, so perhaps it would be easier using that setup?
P.P.S: I understand that mixing kits will limit the capabilities and maximum stable frequencies, but I chose 2 kits that match as closely as possible. Unfortunately they are of different revisions.