Jump to content
Corsair Community

MP500 log entries increment


Recommended Posts

Hi everyone. I have Corsair MP500 120 Gb installed on my ASUS Z97I-Plus. Everything works fine. But I have noticed that parameter "Number of Error Information Log Entries" increments each time before OS starts to load on every turn on or reboot.

Current value of this parameter is 5042 (from Corsair SSD Toolbox). All other SMART attributes are OK.

 

Example of error log from Ubuntu nvme (all errors are similar):

 

.................

Entry[ 0]

.................

error_count : 4823

sqid : 0

cmdid : 0xe

status_field : 0x4004

parm_err_loc : 0xffff

lba : 0x80001000100

nsid : 1

vs : 0

 

So... is this normal for this SSD, or it's a defect or I should change some UEFI settings?

 

I am In confusion, because I have another system with ASUS H97I-Plus + Plextor M8Pe 256GB and no errors on its SMART.

Link to comment
Share on other sites

  • Corsair Employee
Check the MP500 physically, ensure that the contacts are clean and that any debris in the M.2 slot on your motherboard is removed. Reinstall the drive and see if the error count increases. I would also recommend changing M.2 slots, but you're limited to just the one on the back of your motherboard unfortunately. :S
Link to comment
Share on other sites

  • 1 month later...

I have that ssd on a Z97 board

mine shows the same thing: https://pastebin.com/s0sgepxh

 

here is the smart log from mine:

Smart Log for NVME device:nvme0 namespace-id:ffffffff
critical_warning                    : 0
temperature                         : 66 C
available_spare                     : 100%
available_spare_threshold           : 1%
percentage_used                     : 0%
data_units_read                     : 43,534
data_units_written                  : 34,243
host_read_commands                  : 372,578
host_write_commands                 : 441,100
controller_busy_time                : 2,319
power_cycles                        : 20
power_on_hours                      : 51
unsafe_shutdowns                    : 6
media_errors                        : 0
num_err_log_entries                 : 3,206
Warning Temperature Time            : 0
Critical Composite Temperature Time : 0
Temperature Sensor 2                : 74 C
Thermal Management T1 Trans Count   : 0
Thermal Management T2 Trans Count   : 0
Thermal Management T1 Total Time    : 0
Thermal Management T2 Total Time    : 0

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...