Goa Posted May 17, 2019 Share Posted May 17, 2019 Hello, im using H80i v2, i renewed thermal paste. Its worked properly for 5 mins but after that its over heated and when i checked the thermal pastes its all melted. Is anyone have the same problem. And do i need the check the water for pupming system. If yes how? Link to comment Share on other sites More sharing options...
c-attack Posted May 17, 2019 Share Posted May 17, 2019 In Link/iCUE, the cooler has its own section. The temperature there (or H80i v2 Temp) is the coolant temperature. It should range between your room temperature (when powered off) up to around 40C or so. In a cool room and with sub-maximal load, much less. If you see coolant temperatures in the 50C+ range, something is wrong with the cooler. If they are in the 25-35C range, then it likely is a contact issue. Also, make sure the header powering the H80i v2 is set to 100%/Full speed or "disabled" in the Advanced BIOS. If it does not get the full 12v, the pump may not start. Link to comment Share on other sites More sharing options...
Recommended Posts