IBM Intellistation PSU P2 connector mismatch

Harry White · #1 11-05-2009, 06:25 PM

Hi,
I have just purchased the VX550W to replace the OEM PSU in my IBM Intellistation M Pro Model 6230-38U. The P2 connector on the PS does not match the receiver on the motherboard.

My motherboard connector is looking for this type of connector:

http://www.freeopenbook.com/upgradin...html#ch21fig14

Help? Thanks.

Harry
NW Connecticut

Wired · #2 11-05-2009, 07:51 PM

It splits into two pieces. One of them will fit.

Harry White · #3 11-05-2009, 08:46 PM

Thanks. However, the pin design is different .. not a barrel type but a narrow slot across the connector.

http://www.freeopenbook.com/upgradin...html#ch21fig14

See Figure 21.14. ATX auxiliary power connector.

Regards,
Harry

Wired · #4 11-05-2009, 09:51 PM

Can't say I've ever seen that type of connection on a retail PSU. I'd talk to IBM to see what PSU they recommend.

FEAR6655 · #5 11-05-2009, 10:24 PM

Quote:

Originally Posted by Wired

Can't say I've ever seen that type of connection on a retail PSU. I'd talk to IBM to see what PSU they recommend.

It was used on server/workstation motherboards until ATX2.0 came out.

Harry White · #6 11-06-2009, 07:16 AM

So..... since there is no IBM support for the Intellistation line, am I out of luck or ? Thanks.

Wired · #7 11-06-2009, 06:47 PM

If it's a pre ATX v2.0 spec cable, then you're unfortunately out of luck as the PSU is ATX 2.01+ compatibile. I'd return it, or see if there's a converter cable you can get maybe?