KumoriDragon Posted January 24, 2019 Share Posted January 24, 2019 I just installed my RGB fan hub to my Lighting Node Pro but only two LEDs in the fan are working...one is solid red, the other changes to the settings, but the entire fan will not light up. What am I doing wrong? Image to show what I mean: https://imgur.com/a/G0HWBvQ Link to comment Share on other sites More sharing options...
DevBiker Posted January 24, 2019 Share Posted January 24, 2019 I don't think that you are necessarily doing anything wrong. It sounds like the fan is bad. Link to comment Share on other sites More sharing options...
Tush Posted January 30, 2019 Share Posted January 30, 2019 I've been have a similar issue as well! Software detects my lighting node pro but I can't adjust my rgbs. My fans are left just like your picture. 1 fan is blue, 1 with no light, and 1 red but just like your picture its not completely lit. Link to comment Share on other sites More sharing options...
Zzguegui Posted January 30, 2019 Share Posted January 30, 2019 I had the same problem I have already done 2 back to see if it is the fact that the fans failed but to date it still does not work just at the first start or they were working properly Link to comment Share on other sites More sharing options...
fab1 Posted February 21, 2019 Share Posted February 21, 2019 I‘ve got the same issue. LL140 are showing 2 colors but I can’t change the rgb lights in the software. are there any solutions in the forum? Link to comment Share on other sites More sharing options...
EinFallsLos Posted April 3, 2019 Share Posted April 3, 2019 I have encountered the same issue. I tinkered with the rgb hub a bit and figured out that if you unplug the sata power, then power on the system and then plug it back in all works just fine. However thats not really a permanent solution.. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.