View Single Post
Old 09-17-2018, 12:06 PM
cc10101 cc10101 is offline
Registered User
cc10101's PC Specs
Join Date: Aug 2018
Posts: 53
POST ID # = 973130
cc10101 Reputation: 13

Originally Posted by Zotty View Post
1000D Commander Pro Chassis Lighting setup

Connected to LED Channel 1 of the Supplied Commander Pro is the Chassis Lighting Connector, The Cable heads off to the Front of the Case to Feed both the Front IO LED's and the Sails Logo in front of the Front fans.

When looking up towards the top right corner of the case (internally) by the rear of the Front Fan Tray you should see an RGB female Socket hanging.

To the above mentioned socket you can attach 6 Corsair Lighting Pro Strips or a Corsair RGB Fan LED Hub and 6 Corsair RGB Fans.


In Icue.

The 1000D Commander Pro has the Normal 2 lighting channels like the Normal Commander Pro but also has a Chassis Lighting option

Chassis Lighting tab.

As you can see in the above image you have 4 LED's for the Sails Logo and 18 LED's for the Front IO panel.

Lighting Setup tab

As you can see its like any other Commander Pro. 6 Corsair Lighting Pro strips or 6 Corsair RGB Fans (via the RGB Fan LED Hub) Per channel

Lighting Channel 1

I have 6 strips for internal Lighting on mine

Hi Zotty. Quick question for you about the 1000D "built-in" Commander Pro.

You said, above, that in iCUE there should be the chassis lighting section and two lighting channels. I see the chassis lighting section and lighting channel 2. But I do not see a lighting channel 1.

Is that because I never plugged anything into the RGB female cable socket that hangs down from the top-front of the case (that you circled in the photo above)?

I didn't realize that we could plug a fan hub into that. Thought it was just for LED strips. That's good to know, so thanks for that info, as well as for the thread in general.
Reply With Quote