View Single Post
  #4  
Old 07-18-2010, 09:13 PM
Elganja Elganja is offline
Registered User
Elganja's PC Specs
 
Join Date: Nov 2009
Posts: 11
POST ID # = 457877
Elganja Reputation: 10
Default

chipset waterblocks installed


cpu block installed and some tubing ran (note the routing changed later on as you will see)


motherboard installed and some more tubing ran... had to change the routing for the chipset and cpu so it wouldn't interfere with the rear fan and gpu


most of the tubing at this point was ran, just not connected as I waited for more parts to arrive


out with the old (2 gtx 295's) and in with the new... 2 EVGA GTX 480 FTW Hydro copper's


everything installed and wor********. in terms of fan flow, everything is intake except the 3 fans on the top radiator which are exhaust


how the tubes will be ran on the backside... nothing will overlap (although there is ample wiggle room)


front view of the case...
-fan controller settings are as follows (left to right)
--1 thru 3, top 3 fans
--4, bottom 2 fans on one knob
--temp sensor 1 - HDD cage (used one of the supplied thermos)
--temp sensor 2 - Loop 1 Fluid
--temp sensor 3 - Loop 2 Fluid
--temp sensor 4 - case temp (used one of the supplied thermos)
-all fans are run at 50% (trying to keep it quiet)


in it's final place... picture is a little over exposed
Reply With Quote