View Single Post
  #3  
Old 01-26-2010, 04:17 PM
Mnpctech.com's Avatar
Mnpctech.com Mnpctech.com is offline
Registered User
 
Join Date: Nov 2009
Posts: 467
POST ID # = 436855
Mnpctech.com Reputation: 10
Default

Maybe you've debated about painting your Obsidian chassis. This is how I remove the plastic "Tool-less" 5.25 bay sliders without breaking the tiny plastic tabs inside. These tabs hold the slider onto the bay. You will need to bend the metal tabs as I illustrate here. You need to first file down the sides of the metal tab, so it will sit flush when you flatten it (not shown). I will then tap the metal tab with a flat head screw driver using a rubber mallet.

Keep in mind if you're painting your chassis, you will need to bend the metal tabs back into place after re-installing the sliders. Doing this will likely chip your new paint! so you'll have to re-touch these tabs again. After considering this thought, I've decided to eliminate the sliders altogether. Corsair has left the option of fastening in your optical drive the traditional way with screws. Only 2 screws per side, but thats sufficient enough!






I just barely cleared this flattened tab. Because of the thick factory paint finish, you should file down the sides of the metal tabs first, so they will sit flush when you flatten them.

Last edited by Mnpctech.com; 01-26-2010 at 04:20 PM.
Reply With Quote