timeToy

You can put the 250 on the left and right edge and 2-450 along the top and bottom in a cross fashion. This way each LED is in the right "position"

Corsair, come on, this is a full year now! Do we need to help you buy some monitors for your devs?

I received a notification "iCUE sensed the thermal probe attached to port #1 on LS1000 starter Kit. Are you trying to setup CORSAIR Hydro X Series Custom Cooling" I do have 2 LS100 Starting Kit, and NO I do no have or try to Setup CORSAIR Hydro X Series Custom Cooling. I have a H115i elite. Dismissing the notification will bring it up the next time iCUE us loaded

I have a H115 Elite Capellix, I am very happy with the thermal performance. I have added 2 fans in push-pull and set the stock fans to Zero-RPM mode and the additional fans to Quiet mode. All is good under normal usage, but when I lock the computer (Control+Alt+Del + Lock) then all the fan goes to full speed (and crazy noisy) Is it just me or is it is the proper behavior?

Still looking into it almost a year after? The issue is still here in iCue 3 and 4!

Works fine for me HX1000i is detected and reporting in iCue 4 (I do not have Link installed)

I have 3 monitors #1: Portrait mode on the left side #2: Main Monitor 21x9 #3: Landscape mode on top of the Main Monitor I have my LS100 Starter kit installed behind monitor #2. - If I only enable Monitors #2 and #3 the Video Lighting option monitor selection show both monitors and they match the physical monitors, all works as intended. No problems - If the #1 monitor is enabled, then I can see the 3 monitors to choose from the Video Lighting option monitor selection list, with the proper names, BUT selecting them do not select the proper monitor, as a matter of fact selecting 2 of the monitors does nothing and the only monitor that work is then mislabeled (labelled as monitor #2 when it picked up monitor #3). This is a very annoying bug that prevent people with 3 monitor to use the product as intended. Thanks

I have the same issue. The Light Node Pro works fine with my LL Fans, but with the light strips, 2/3 of the LEDs stop working after a few minutes. Disconnecting and reconnecting doesn't help, I have to power off the computer for them to work again (for a few minutes).