belezeebub

I wasn't planning on changing my case but I found out today that the Motherboard I want is XL-ATX Form Factor; 32.5cm x 27.5cm Before I plop down for a 1000d can anyone tell me if it supports this new form factor I can find very few cases listing XL-ATX, I tried contact Thermaltake because I currently have "The Tower 900" but as normal for Thermaltake I get most answers asking any blank wall.

This will be my 50th Water cooled PC while I have used temp sensors before I was never a fan of the extra wires. most of my builds have used an Aquaero 5 or 6 CPU temp has always worked for fan control but for 20 bucks I won't fight over it, does the corsair use the normal 10K versions? I don't want Flakey if the Onboard USB has issues I can add something like this https://********/wzywucp or https://********/wmhlm9r (I guess this forum blocks tinyurl so the links don't work

That is one of the reasons I am using three commander pros I am hoping I can assign different effects to different Cmdr pros and RGB My plan is loop 1(cmdr1) CPU fans ramp up with CPU temp, Loop 2(Cmdr2) GPU fans ran up with GPU temp CMDR 3 Temp sensors fans ramp up with case temp All 8 Radiator fans are breathing red all 5 out fans are breathing red I have a single 5mm RGB led for the EYE Memory is read shimmer Video card is a 2080ti with the corsair block (I might put in the gigabyte 2080ti Waterforce extreme EK but to be honest I didn't like all the rainbow colors on the side I am building this all in my Old case once the parts get here

I was talking about this one https://www.corsair.com/us/en/Categories/Products/Fans/RGB-%26-LED-Fans/iCUE-SP-Series-RGB-PRO-Performance/p/CO-9050096-WW Really wanted to know if my plan for the wiring would work< I can find little info about Daisy Chaining Commander Devices, the Thermaltake you can set the address on

Okay I am building my New system Thermaltake "The Tower 900" 2x140x4 Rads Dual 270 D5 Pumps blah blah blah Down to my questions Loop 1 CPU 4x140 Thinking I will use SP140 Connected to Corsair Commander pro (Master) Loop 2 4x140 Thinking I will use SP140 Connected to Corsair Commander pro (Slave1) Case Fans 5 LL140's connected to Corsair Commander Pro (Slave2) USB On Motherboard to Corsair Commander Pro (Master) USB 1 on Corsair Commander Pro (Master) to Commander Pro Slave 1 USB 2 on Corsair Commander Pro (Master) to Commander Pro Slave 2 I also need three of the RGB hubs can I still connect them to them in this manner One on each of the commander Pros Will this work?